Wiper Frame With Linkage And Windshield Wiper Motor -V-, Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Torque Wrench 1331 5-50Nm:VAG1331
Puller - Wiper Arm Kit - Puller 5:T10369/5

CAUTION:

When connecting battery, always perform work procedure as described in repair manual. Refer to BATTERY, DISCONNECTING AND CONNECTING . Failure to follow the sequence can trigger the battery cut-off relay and damage the electrical equipment.
Observe notes for threaded connections of battery terminals. Refer to BATTERY POST/TERMINAL .

-- Connect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Let Windshield Wiper Motor -V- run to rest position. Connect the connector to the Windshield Wiper Motor -V-, turn on the ignition and briefly operate the windshield wiper switch (one-touch wiping).

NOTE:

The hood (Engine Hood Contact Switch -F266-) must be closed in order to use the windshield wipers.

-- Turn off the ignition and disconnect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Install the wiper frame with the linkage and Windshield Wiper Motor -V- in reverse sequence.

-- Tighten the bolts for the wiper frame to the tightening specification found in the assembly overview. Refer to OVERVIEW - WINDSHIELD WIPER SYSTEM .

NOTE:

If Wiper Motor Control Module -J400- or Windshield Wiper Motor -V- is replaced, Wiper Motor Control Module -J400- must be coded. Refer to Wiper Motor Control Module -J400-, CODING .

-- Connect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .