LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2012 >> S4 Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1260 (Communication) >> 91 Communication >> Digital Sound System Control Module -J525- >> Digital Sound System Control Module, Removing And Installing >> Removing:
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Digital Sound System Control Module, Removing And Installing: Removing:

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

The amplifier and the Digital Sound System Control Module -J525- -1- are inside the luggage compartment behind the left side trim panel.

GWWN91-11785Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If the control module is replaced, select the "Replacement" function for the appropriate control module in "Guided Fault Finding".

Connect the Vehicle Diagnostic Tester to do this.

Perform the Following Steps:

-- Turn off the ignition and all electrical equipment.

-- Remove the left side trim panel. Refer to LUGGAGE COMPARTMENT TRIM PANELS .

Vehicles with Rear Heater and A/C Unit

GWWN91-11784Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the noise insulation foam piece -1-.

-- Remove the bolts -arrows- from the heater and A/C Unit.

GWWN91-11786Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Move the heater and A/C Unit in direction of -arrow-. The wire connections and hoses remain connected.

GWWN91-11787Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Continued for all vehicles

GWWN91-11788Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows-.

-- Remove the Digital Sound System Control Module -J525- and mount.

-- Disconnect the connector from the amplifier.

-- On the "RNS 850" versions, install the Fiber-Optic Repair Set - Connector Protective Caps:VAS6223/9  on the fiber-optic cable pulled off the Digital Sound System Control Module -J525-.

NOTE:

Fiber-Optic Cable Is Very Delicate!

The Fiber-Optic Cable Must Not Be Kinked Or Significantly Bent!

The bending radius must not be less than 25 mm.

A kinked fiber-optic cable is no longer usable, data transfer via kinked fiber-optic cable is faulty!

Please do not remove the protective caps from the ends of the fiber-optic cable until the fiber-optic cable is connected to the intended unit.