Chip Card Reader Control Module, Removing And Installing: Notes
WARNING: This page is about a different car, the 2021 Audi e-tron Quattro and 2019 Audi e-tron Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The Chip Card Reader Control Module -J676- is located in the glove compartment, Japan (ER5).
If the Chip Card Reader Control Module - J676- is replaced, the following procedure applies:
-- Connecting and switching on the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Diagnostic-capable systems
- 005F - Information Electronics Control Module 1 - J794 (MIB 2+) or 005F - Information Electronics Control Module 1 - J794 (MIB 3)
- 005F - Information Electronics Control Module 1, functions
- 0642 - Chip Card Reader Control Module -J676 replacing
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.