Engine Component Power Supply Relay - J757-, Checking: Notes

General Description

The following procedure is used to diagnose the Engine Component Power Supply Relay -J757- and the power supply voltage that is provided to the engine components.

Special Tools And Workshop Equipment Required

Multimeter.
Wiring Diagram.
Scan Tool.

Test Requirements

Fuses OK.
Battery voltage OK.
Switch OFF all electrical and electronic accessories.
Vehicles with automatic transmission, ensure the selector lever position is in "P".
Vehicles with manual transmission, ensure the shifter lever position is in "N" with the parking brake applied.
Observe all safety precautions: SAFETY PRECAUTIONS .
View clean working conditions: CLEAN WORKING CONDITIONS .

Test Procedure

Step	Procedure	Result / Action to Take
1	PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK . -- Was Complaint verified?	-- YES: GO TO: Step 2 Engine Component Power Supply Relay - J757-, CHECKING - 2 . -- NO: GATHER more information from customer about the complaint.
2	IGNITION: OFF. DISCONNECT: Engine Component Power Supply Relay -J757- from the Fuse box in the engine compartment. IGNITION: ON. CHECK: Engine Component Power Supply Relay -J757- socket terminals 2 and 6 to ground for voltage. IGNITION: OFF. SPECIFIED VALUE: Battery voltage. -- Were Values obtained?	-- YES: GO TO: Step 3 Engine Component Power Supply Relay - J757-, CHECKING - 3 . -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 5 Engine Component Power Supply Relay - J757-, CHECKING - 5 .
3	CONNECT: Jumper wire, between the Engine Component Power Supply Relay -J757- socket terminals 2 and 8. DISCONNECT: Oxygen Sensors -- harness connectors. IGNITION: ON. CHECK: Oxygen Sensors -- harness connector terminals 1 or 4 to ground for voltage (refer to appropriate wiring diagram for correct terminal and connector locations). IGNITION: OFF. SPECIFIED VALUE: Battery voltage. -- Were Values obtained?	-- YES: GO TO: Step 4 Engine Component Power Supply Relay - J757-, CHECKING - 4 . -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 5 Engine Component Power Supply Relay - J757-, CHECKING - 5 .
4	REMOVE: Jumper wire, between the Engine Component Power Supply Relay -J757- socket terminals 2 and 8. REMOVE: Engine/Motor Control Module -J623-. Refer to appropriate service information. CHECK: Engine Component Power Supply Relay -J757- socket terminal 4 to the Engine/Motor Control Module -J623- harness connector T94 / 32 for resistance. SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω). -- Was Value obtained?	-- YES: REPLACE: Engine Component Power Supply Relay -J757-. Refer to appropriate service information. GO TO: Step 5 Engine Component Power Supply Relay - J757-, CHECKING - 5 . -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 5 Engine Component Power Supply Relay - J757-, CHECKING - 5 .
5	Refer to the Final Procedure Below