LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2012 >> S5 4.2, Standard Trans >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning (Front Heater & A/C Unit) (Coupe) >> 87 Air Conditioning >> Battery Cooling Module >> Battery Cooling Module, Removing And Installing >> Installing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Battery Cooling Module, Removing And Installing: Installing

Installation Is Carried Out In The Reverse Order While Observing The Following. 

NOTE:

Follow the instructions for installing the O-rings. Refer to REFRIGERANT CIRCUIT SEALS .

Following attachment, check routing of refrigerant lines. They must be inserted in holders provided and not make contact with other components.

-- Replace the O-ring seals -4-. For the correct version. Refer to the Parts Information.

Fig 1: Identifying Refrigerant Line Connection Components
GWWA87-11043Courtesy of AUDI OF AMERICA, LLC

-- Clean the refrigerant line connections -3 and 5- and inspect them for damage.

-- Make sure the O-rings -4- sit correctly inside the grooves of the respective mount.

-- Check the alignment pin -2- (not present on all connections) for damage and make sure that it is seated correctly.

-- Tighten The Bolts -1-.

-- Install The Refrigerant Lines For The Battery Cooling Module In The Luggage Compartment. Refer To REFRIGERANT LINES FOR BATTERY COOLING MODULE IN LUGGAGE COMPARTMENT, REMOVING AND INSTALLING .

-- Install The Remaining Removed Components.

-- Electrical Connections And Routing. Refer To Wiring Diagram.

-- Evacuate The Refrigerant Circuit And Fill It. Refer To REFRIGERANT CIRCUIT, DISCHARGING WITH A/C SERVICE STATION , REFRIGERANT CIRCUIT, EVACUATING WITH A/C SERVICE STATION , and REFRIGERANT CIRCUIT, CHARGING WITH A/C SERVICE STATION (Refrigerant R134a, Servicing; Refrigerant Circuit, Using Service Station).

-- Turn On The Ignition.

-- Check the DTC memory for the Climatronic Control Module -J255- display and control head and erase any displayed malfunctions, if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

-- Operate the A/C system after filling the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

NOTE:

Observe the information regarding operating the A/C system after filling. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT - 1 , A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT - 2 (Refrigerant R134a, Servicing; A/C System, General Information). After charging the A/C system before activating the A/C system.