Auto Headlight Beam Leveler System: Procedure: Notes

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

When parts related to the auto headlight beam leveler system are removed or replaced, perform the following procedures to initialize or reinitialize.

NOTE: Before performing initialization or reinitialization, check the following:

Vehicle is parked on a level surface.
The inflation pressure of tires is correct.
Unload any cargo from the vehicle.
Vehicle's fuel tank is fully filled.
Refer to the following chart to determine whether to initialize or reinitialize.

INITIALIZATION AND REINITIALIZATION CHART

Initialization	When the auto headlight beam leveler control module has been replaced with a new module.
Reinitialization	When the auto headlight beam leveler control module has been replaced with a part from a different vehicle. When suspension parts have been removed or replaced. (Crossmember, front arm, housing, lateral link, strut) When the vehicle height sensor has been replaced or removed.