Monitor-ID $3D : EVAP Valve Function Check
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Monitor-ID $3D".
-- Select the desired "Test-ID (TID)" or "Hex-ID".
-- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $80 | P0441 | Tank vent valve check from % DTEV: Active test Air balance at idle OK, (Normal operation and short test 70). | 0.300 % | 1.999 % | Refer to DTC P0441 in the DTC summary table. Engine Control Module -J623- DTCS, 2013-2014 => P0441 . |
| $88 | P0441 | Tank vent valve check from %DTEV: Active test, Oxygen sensor regulator deviating in lean direction (can only test OK), (Normal operation and short test 70). | 1.0 counts | 65535.0 counts | Refer to DTC P0441 in the DTC summary table. Engine Control Module -J623- DTCS, 2013-2014 => P0441 . |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Ignition switched OFF.