Front Display Front And Rear Cover, Removing And Installing: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi S6, and 2014 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Danger of causing damage to the vehicle electronics
- Requirement: Make sure nothing, especially metal or other light weight particles, can get onto the display.
- Make sure also no oil, grease, silicone or other such materials can get onto the removed display, otherwise they can turn into steam and fog up the display.
- Touching electronic circuits with bare hands can lead to migration.
- ESD (electro static discharge) protection: Always follow standard DIN EN 613-40-5-1 when handling.
- Do not use any components or electronics that have fallen down.
- ESD Work Surface VAS6613. Refer to ESD WORK SURFACE VAS 6613 .
The Front Information Display Control Head -J685- can be disconnected from the kinematics. The front and rear covers can be replaced individually if they are scratched or faulty.
The Front Information Display Control Head -J685- consists of a front cover -1-, a display -2-, display support -3- and a rear cover -5-. The display and the display support are attached with screws -4- and the front and rear covers are clipped on.
The display is supplied installed with the mount. The front cover -1- and rear cover -5- can be ordered and replaced separately.
-- Turn off the ignition and all electrical consumers and remove the ignition key.