Camshaft Position Sensor -G40-, Checking: Notes

General Description 

Using the signal from the Camshaft Position Sensor -G40-, the precise position of the camshaft relative to the crankshaft is determined very quickly when the engine is started. Used in combination with the signal from the Engine Speed Sensor -G28-, the signal from the Camshaft Position Sensor -G40- allows the Engine Control Module -J623- to detect which cylinder is at TDC. The fuel can be injected into the corresponding cylinder and ignited.

Special Tools And Workshop Equipment Required 

• Multimeter.
• Wiring Diagram.
• Scan Tool.

Test requirements 

• Fuses OK.
• Battery voltage OK.
• Switch OFF all electrical and electronic accessories.
• Vehicles with automatic transmission, ensure the selector lever position is in "P".
• Vehicles with manual transmission, ensure the shifter lever position is in "N" with the parking brake applied.
• Observe all safety precautions: SAFETY PRECAUTIONS .
• View clean working conditions: CLEAN WORKING CONDITIONS .