Readiness Drive Cycle Procedure

-- CONNECT: Scan Tool.

Step	Procedure	Result / Action to Take
1	Activate Monitors: START: Engine and idle for 2 - 3 min.	Monitoring Active. Executes Misfire Monitoring.
2	O2 Sensor Monitoring: DRIVE: Vehicle at 45 - 55 mph for a continuous 7 minute period. Avoid stopping.	Executes O2 Sensor Monitoring. Executes Fuel Trim Monitoring. Executes EVAP Monitoring.
3	Fuel Cut-Off Monitoring: ACCELERATE: Vehicle to an engine speed of 5, 000 RPM; lift off the throttle until the engine speed is around 1, 200 RPM.	Fuel Cut-Off Monitoring Ready.
4	Catalyst Monitoring: ACCELERATE: Vehicle smoothly to 60 - 65 mph, cruise at a constant speed for 5 min.	Executes Catalyst Monitoring. Executes O2 Sensor Monitoring. Executes Fuel Trim Monitoring. Executes Misfire Monitoring. Executes EVAP Monitoring.
5	Secondary Air Injection, EVAP Monitoring: DRIVE: Vehicle for 30 - 40 min. at a constant speed of 50 - 70 mph in high gear for 2 min with no coasting.	Executes Secondary Air Injection Monitoring. Executes EVAP Monitoring. Check the status of the readiness code.

-- If any engine monitor fails the drive cycle test. Repeat the drive cycle test until all engine monitors have successfully run through and passed.

NOTE:

When Repeating The Drive Cycle Operation For A Failed Evaporative Or Thermostat Monitor, Allow The Engine To Cool Until The Coolant Temperature And The Ambient Air Temperature Are Between 10° C And 35° C With A Difference Between Them No Greater Than 4° C And Then Repeat The Drive Cycle Operation.

Depending on the scan tool used, the readiness code status may be displayed as complete, passed or OK. At an ambient air temperature < 7° C, the setting of the readiness for the NOx catalytic converter test is delayed. Here the vehicle must be driven considerably longer.