Diagnostic Mode 09 - Read Vehicle Information

Diagnostic Mode 09 makes it possible to access vehicle specific information from the ECM and the TCM (where applicable).

NOTE:

Depending on the scan tool and protocol used, Diagnostic Mode 09 and the information provided may be referred to by a different name.

Test Requirement

Procedure

-- Connect the scan tool.

-- Switch the ignition on.

-- Select Mode 09: Vehicle information.

-- Select the desired Test ID.

-- The information requested will be displayed on the scan tool screen.

The following table is a numerical list of all Test IDs that may be selected.

Test-ID	Diagnostic text
$02:	Vehicle Identification number e.g.
	A different 17 digit number will be displayed for each vehicle
$04:	Calibration Identification part number and software version
	Engine Control Module --
	Transmission Control Module (TCM) --
$06:	Calibration Verification Number (check sum) e.g.
	The check sum is different for every control module version
$0A:	ECU name
	Engine Control Module --
$0B:	In-use Performance Tracking (IPT Counter)

-- Switch the ignition off.

Service $0A

Request Emission Related DTC's with Permanent Status - SUPPORTED

-- Switch the ignition OFF.