Monitor-ID $3C: Fuel Tank EVAP System Integrity / Very Small Leak Test (0.020" / 0.5 mm)
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 06: Check / test the results of components that are not continuously monitored".
Select "Monitor-ID $3C".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $81 | P0456 | Tank Venting System Leak Test: Fine Leak. | 7.0 s | 65, 535.0 s | Refer to DTC P0456 in the DTC summary table.Engine Control Module --, 2017 MY => P0456 |
| $81 | P0456 | Tank Tightness Testing After Initial Flushing. | 4.5 - 6.0 s | 65, 535.0 s | Refer to DTC P0456 in the DTC summary table.Engine Control Module --, 2017 MY => P0456 |
| $82 | P0456 | Tank Tightness Testing After Initial Flushing. | 5.0 g | 65, 535.0 g | Refer to DTC P0456 in the DTC summary table.Engine Control Module --, 2017 MY => P0456 |
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.