LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2016 >> S6 Premium Plus >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Engine System & Transmission System (Diagnostics - CTGE - 7 Of 8) >> Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions (My-2016) >> Monitor-ID $3D: EVAP Valve Function Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor-ID $3D: EVAP Valve Function Check

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check the results of components that are not continuously monitored".

Select "Monitor-ID $3D".

-- Select the desired "Hex-ID".

-- Check specified values at idle.

(Hex-ID) DTC Component or System Min. Max. Additional Information
$80 P0441 Tank vent valve check, Active test Air balance at idle OK. 0.200012 1.999 Refer to DTC P0441 in the DTC summary table.Engine Control Module --, 2016 MY => P0441 .
$88 P0441 Tank vent valve check, Active test, Oxygen sensor deviating in lean direction (can only test OK). 1.0 counts 65, 535 counts

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals