Digital Sound System Control Module - J525-, REMOVING AND INSTALLING, BANG & OLUFSEN, FROM MY 2015
The Digital Sound System Control Module - J525- - 1- is located behind the left luggage compartment trim panel.
Special tools and workshop equipment required
- Fiber-Optic Repair Set - Connector Protective Caps VAS6223/9
If replacing the control module, select the " Replace Control Module" function on the Vehicle Diagnostic Tester.
Removing
-- Turn off the ignition and all electrical consumers and remove the ignition key.
-- Remove the left luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .
The bracket with the Digital Sound System Control Module - J525- must be removed first.
-- If equipped, remove the trailer hitch lever. Refer to IMPACT MEMBER, REMOVING AND INSTALLING, VEHICLES WITH TRAILER HITCH .
-- Remove the nuts - 4, 6 and 7- and the screw - 2- on the bracket - 1-.
-- Remove the brace - 3-.
-- Pivot the Digital Sound System Control Module - J525- - 5- with the bracket - 1- into the luggage compartment.
-- Release and disconnect the connectors from the Digital Sound System Control Module - J525- - 5-.
-- If equipped, release and disconnect the connectors from the TV Tuner - R78-.
-- Insert the Fiber-Optic Repair Set - Connector Protective Caps VAS6223/9 - 1- onto the MOST bus connector - 2-.
-- Remove the Digital Sound System Control Module - J525- - 5- with the bracket - 1-.
It is not necessary to remove the TV Tuner - R78-.
-- Remove the screws - arrows- and remove the Digital Sound System Control Module - J525- - 1- from the bracket - 2-.
Installing
-- Install in reverse order of removal.
Tightening Specifications