LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2016 >> S7 >> Repair and Diagnosis >> General Information >> Specifications Index >> Common Specs & Procedures (S7) >> Specifications Index
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Specifications Index

SPECIFICATIONS INDEX

System Specification/Procedure
Air Conditioning
Service REFRIGERANT R134A PHYSICAL DATA
Torque FASTENER TIGHTENING SPECIFICATIONS
Axle Nut/Hub Nut
Front 200 Nm +180°
Rear 200 Nm +180°
Battery Cold Crank Amps Table
Brakes
Bleeding Sequence BRAKE SYSTEM, BLEEDING
Disc Brakes BRAKES, TECHNICAL DATA
Torque FASTENER TIGHTENING SPECIFICATIONS
Charging
Generator Generator
Torque

FASTENER TIGHTENING SPECIFICATIONS

Drive Belts
Adjustment
4.0L Ribbed Belt, Removing And Installing
Belt Routing
4.0L See fig. 5 under Installing
Engine Cooling
General Service Specifications Refer to the approrpiate FLUID CAPACITY TABLES information.
Radiator Cap Pressure
4.0L 1.4 to 1.6 bar (20.30 to 23.20 psi)
Thermostat R & I
4.0L Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING
Water Pump R & I
4.0L COOLANT PUMP, REMOVING AND INSTALLING
Engine Mechanical
4.0L
Compression COMPRESSION PRESSURE, CHECKING
Oil Pressure Oil pressure at idle: minimum 1.3 ± 0.3 bar (18.85 ± 4.35 psi).
Oil pressure at 2, 000 RPM: minimum 1.6 to 2.2 bar (23.2 to 31.9 psi).
Overhaul 10 ENGINE ASSEMBLY
Torque Engine, Installing
Fluid Specifications See FLUIDS under MAINTENANCE tab.
Engine Oil Drain Plug 20Nm
Flywheel/Flex Plate Torque 60 Nm + 90°
Fuel System
Pressure Specification
4.0L The fuel injection system is separated into a high-pressure section (maximum approximately 120 bar (1740 psi)) and a low-pressure section (4 to 7 bar (58 to 101 psi)).
Fuel Pressure Test Procedure
4.0L Fuel Delivery Unit/Fuel Level Sensor
Ignition
Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
Ignition Wires (Resistance) Coil-On-Plug
Ignition Wires (Routing) Coil-On-Plug
Spark Plug
4.0L TEST DATA AND SPARK PLUGS
Starting
Starter STARTER (CEUC and CRDB)
Torque FASTENER TIGHTENING SPECIFICATIONS
Wheel Alignment
Adjustment Specifications Axle Alignment Specified Values
Torque Front Fastener Tightening Specifications
Rear FASTENER TIGHTENING SPECIFICATIONS
Wheel & Tire
Wheel Lug Nut Torque 120 Nm