External Audio Source Connection -R199- REMOVING AND INSTALLING, CONNECTION IN CENTER CONSOLE

WARNING: This page is about a different car, the 2017 Volkswagen Touareg, 2016 Volkswagen Touareg, and 2015 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Removing:

Perform the following steps:

-- Turn off the ignition and all electrical equipment.

-- Open the front center armrest.

-- Disconnect the wire connection -arrow- from the harness connector.

Fig 1: Harness Connector Wire Connection

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the switch trim. Refer to Storage Compartments, Covers and Trim .

-- Pull the trim from the connector housing in direction of -arrow- by releasing the tabs from the rear side.

Fig 2: Identifying Trim From Connection Housing, Removal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the catch -arrow-.

-- Slide the External Audio Source Connection -R199- -1- forward out of the storage compartment.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installing:

Install in reverse order of removal.