Rain/Light Recognition Sensor -G397-, REPLACING: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2021 Audi S8, 2021 Audi A8 e Quattro, 2021 Audi A8 Quattro, 2020 Audi S8, and 2020 Audi A8 e Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

CAUTION:

There is a risk of damaging the humidity sensor through improper handling.

-- Gently press the grip surfaces -arrows- on the protective cap -2- together and remove from the sensor -1-.

Fig 1: Identifying Protective Cap

Courtesy of AUDI OF AMERICA, LLC

TIP:

To avoid contaminating the silicone pad, remove the protective cap just before installing it.

-- Insert the sensor -4- into the mount -2-.

Fig 2: Identifying Rain/Light Recognition Sensor

Courtesy of AUDI OF AMERICA, LLC

The Rain/Light Recognition Sensor -G397- must not have any embedded objects or bubbles between it and the windshield so that it functions correctly.

-- Press on the clips -1 and 5- until they audibly engage.

-- Connect the connector -3-.

-- After replacing the rain/light recognition sensor, it must be re-coded in "Guided Functions" mode using the Vehicle Diagnostic Tester.