Retaining Plate for Distance Regulation Control Modules -J428-/-J850-, Removing and Installing: Installing
Install in reverse order of removal. Note the following:
NOTE:
- Replace the quick release.
- The stud bolts in the bracket are pre-set. If necessary, correct the setting.
- If the stud bolts were removed, then the clips on the distance regulation control module must be replaced. Refer to Clip on Distance Regulation Control Module -J428-/Distance Regulation Control Module 2 -J850-, Replacing .
- Place the control module on a soft and clean surface.
- Measure the dimension -a- at all stud bolts using the Digital Caliper -VAS6335- and correct if necessary.
- The dimension -a- = 43.3 mm.
- Position the retaining plate -2-onto the distance regulation control module -3-.
- Carefully press the new quick release -4- onto the stud bolt -2-.
- Turn the quick release clockwise onto the retaining plate to the stop.