8 Inch Display With Kinematics, Removing And Installing: Installing
-- Install in reverse order of removal. Note the following:
-- Make sure that the wiring guide of the Front Information Display Control Head -J685- to the wiring harness and Information Electronics Control Module 1 -J794- is followed exactly -arrows-, otherwise the Front Information Display Control Head -J685- will not extend out.
-- First install the clip in the center -2-, then connect the display connector -1 and 3- and then install the rear clip -4- and finally connect the engine connector -5-.
-- Slide the Front Information Display Control Head -J685- into the instrument panel and tighten the screws -2- hand-tight.
After installing the center vents, align everything and tighten the screws.