LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2017 >> RS 7 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Communication System (Service Information) >> Communication >> Infotainment System >> Overview - Infotainment System >> Overview - Infotainment System, MMI Navigation Plus, 7T6, Through My 2014
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Overview - Infotainment System, MMI Navigation Plus, 7T6, Through My 2014

7T6 - MMI Navigation Plus 

GWWA91-11752Courtesy of AUDI OF AMERICA, LLC
  1. Roof Antenna -R216-
  2. Front Information Display Control Head -J685-, Display in Center of the Instrument Panel
  3. Multimedia System Control Head -E380- in the Center Console
  4. Information Electronics Control Module 1 -J794- Inside the Instrument Panel
  5. Telephone Baseplate -R126- /External Audio Source Connection -R199- in the Center Console Storage Compartment
  6. MOST Bus
  7. Data Bus On Board Diagnostic Interface -J533- Under the Rear Bench Seat
  8. Digital Sound System Control Module -J525- in Luggage Compartment on Left Rear Side
  9. Radio -R- in the Luggage Compartment on the Left Rear Side
  10. CVBS Cable
  11. TV Tuner -R78- on the Left Side of the Luggage Compartment in the Rear
  12. DVD Changer -R161- in the Glove Compartment
  13. Left Front Microphone -R140-, Microphone Unit in Front Roof Module -R164- in the Front Interior Lamp -W1-

The MOST bus performs the system data exchange in the MMI.

The connection to the other Data bus systems in the vehicle are provided by the Data Bus On Board Diagnostic Interface -J533-.

Fault finding is performed via "Guided Fault Finding"  on the Vehicle Diagnostic Tester.

Notes On MOST BUS 

The optical Data bus "MOST bus" is used in addition to the CAN bus.

A fiber-optic cable is used as a "connecting cable". Fiber optic cables are routed inside corrugated tubes for protection.

Replace complete fiber optic cable if possible.

The front surface of the connectors must not be dirty.

If disconnecting the connectors: Attach :VAS6223/9  .

GWWW00-11495Courtesy of AUDI OF AMERICA, LLC

When installing fiber optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink fiber optic cables.

Repairing fiber optic cables. Refer to FIBER-OPTIC CABLES, REPAIRING .