Climatronic Control Module -J255-, REMOVING AND INSTALLING: Notes
Special Tools And Workshop Equipment Required
- Trim Removal Wedge :3409
- Hook Tool :T40207
-- If the Climatronic Control Module -J255- control head is being replaced, select "Replace Control Module" using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.
Depending on the Audi A6 e-tron version, the measured value for the Evaporator Vent Temperature Sensor -G263- can be evaluated by the Climatronic Control Module -J255- control head (as on all other vehicles of this model line) or by the Thermal Management Control Module -J1024-. Use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function and refer to the Appropriate Wiring Diagram.
If the measured value is evaluated by the Thermal Management Control Module -J1024- on the Audi A6 e-tron (and is transmitted via the data bus to the Climatronic Control Module -J255-), there is a different version of the Climatronic Control Module -J255- installed. Use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function and refer to the Parts information.