Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING: Installing

Install in reverse order of removal. Note the following:

• If only the Electronic Steering Column Lock Control Module -J764- was replaced, use the previously used control module bolt.
• If the steering column was replaced, remove the protective cover and use the bolt in the new steering column for the Electronic Steering Column Lock Control Module -J764-.

-- Insert the Electronic Steering Column Lock Control Module -J764- with the tab -arrow A- into the groove -arrow B- in the steering column and then push on the Electronic Steering Column Lock Control Module -J764- by hand.

Courtesy of AUDI OF AMERICA, LLC

-- Once the Electronic Steering Column Lock Control Module -J764- -2- is touching the entire surface of the steering column, install the bolt -1- and tighten it.

Courtesy of AUDI OF AMERICA, LLC

-- Install the steering column. Refer to STEERING COLUMN, REMOVING AND INSTALLING .

-- If the Steering Angle Sensor -G85- indicator lamp in the instrument cluster comes on, correct the fault and, if necessary, perform a basic setting on the dynamic steering. Refer to DYNAMIC STEERING BASIC SETTING .