Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING: Removing
WARNING:
Note the following before removing the steering column:
Create a sketch showing the:
- Routing of the electrical wiring harnesses,
- Securing the electrical wiring harnesses,
- Cable tie locations.
This especially applies to the wiring harness to the Electronic Steering Column Lock Control Module -J764-.
Note the following before installing the steering column:
- Route the electrical wiring harnesses exactly the way they were before removal.
- Secure the electrical wiring harnesses exactly the way they were before removal.
- Install all the cable ties that were loosened or cut in the same locations when installing the steering column.
- Make sure the wiring harness to the Electronic Steering Column Lock Control Module -J764- is not pinched and does not come into contact with sharp edges when adjusting the steering column.
-- If the control module is being replaced, then select "replace" control module on the Vehicle Diagnostic Tester in Guided Functions .
-- Remove the steering column. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
-- Remove the bolt -1- and the Electronic Steering Column Lock Control Module -J764- -2-.
WARNING:
- After removing the control module, make sure no dirt or foreign objects enter the steering column.