Rearview Camera System Control Module - J772-, Removing And Installing, Cabriolet, Through My 2016
The Rearview Camera System Control Module - J772- -1- is located behind the left luggage compartment side trim panel.
NOTE:
If replacing the control module, select the "Replace control module" function for the corresponding control module on Vehicle Diagnostic Tester.
Removing
- Turn off the ignition and all electrical equipment and remove the ignition key.
- Remove the luggage compartment left side trim panel. Refer to Body Interior (Luggage Compartment Trim Panels; Overview - Luggage Compartment Side Trim Panel).
The Rearview Camera System Control Module - J772- -1- is only clipped into the bracket.
- Release and disconnect the connectors -2- from the Rearview Camera System Control Module - J772- -1-.
- Press the catch in direction of -arrow- and remove the Rearview Camera System Control Module - J772- -1- from the bracket.
Installing
- Install in reverse order of removal. Note the following:
- Perform the calibration. Refer to 8.4 Rearview Camera System, Calibrating
.