Heater Control Module -J65- /A/C Control Module -J301- /CLIMATRONIC Control Module -J255-, Removing And Installing: Removing
-- Position the :T40207 (or :3438 ) on the openings -3- and carefully pull the control head -1- out of the mount -2- in direction of -arrow-.
If the control head -1- cannot be removed as described, it must be carefully pressed out of the mount -2- using a plastic wedge -3- (for example with a :T40233 or the wedge T10383/2 from the set :T10383 ) (using the Hook Tool :T40207 or the :3438 to pull) in direction of -arrow-, as shown in the illustration.
If the control head -1- sits so securely in the instrument panel mount that the plastic wedge -3- is deformed when pressing out, a flat-head screwdriver can be used additionally to strengthen the plastic wedge -3- (place between the plastic wedge -3- and the control head -1-).
Depending on the instrument panel there can be a clip (usually the right lower) after loosening the control head -1- that can get hooked in the instrument panel shell, if necessary push this clip for example with a finger (or a screwdriver) toward the control head -1-.
-- Slide the safety mechanism -4- upward in direction of -arrow- and press the release -5- inward to disconnect the connectors -1, 2 and 3-.