Camshaft Position Sensor, Removing And Installing: Installing
WARNING: This page is about a different car, the 2017 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the O-ring if damaged or leaking, if not available separately, then replace entire component
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
After removing or replacing the camshaft position sensor the adaptation values for the chain length must be adapted again.
-- Connect the Vehicle Diagnostic Tester .
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Drive (display depends on the model)
- Select the engine code and engine (display depends on the model)
- 0001 - OBD-Capable Systems or Diagnostic-Capable System
- 0001 - Engine Electronics
- 0001 - Engine electronics, functions
- 0001 - Adaptation diagnostic chain length