Adapting The Adaptation Values After Replacing Components
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
An adaptation of the adaptation values is required after the following procedures:
- The engine was replaced.
- The sensor wheel for the Engine Speed Sensor -G28- was replaced.
- The components of the chain drive were removed and installed or replaced.
- The cylinder head was removed and installed or replaced.
- The camshafts were removed and installed or replaced.
- The Engine Temperature Control Actuator -N493- has been replaced
- The turbocharger with charge air pressure actuator or the Charge Air Pressure Actuator -V465- was replaced.
- The Throttle Valve Control Module -GX3- were replaced.
- The particulate filter was replaced.