BASEPLATE FOR Distance Regulation Control Module -J428-, REMOVING AND INSTALLING, VERSION 2 AND RS3 FROM MY 2017: Installing

Install in reverse order of removal and note the following:

-- Place the control module on a soft and clean surface.

-- Measure the dimension -a- at the upper stud bolt using the : VAS6335  and correct if necessary.

Fig 1: Measuring Dimension --a-- With VAS6335

Courtesy of AUDI OF AMERICA, LLC

• Dimension -a- = 40.25 ± 0.5 mm

-- Measure the dimension -a- at the lower stud bolt using the : VAS6335  and correct if necessary.

Courtesy of AUDI OF AMERICA, LLC

• Dimension -a- = 38.2 ± 0.5 mm

-- Position the retaining plate -3- onto the distance regulation control module -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Carefully press the new quick release -4- onto the stud bolt -2-.

-- Turn the quick release clockwise onto the retaining plate to the stop -arrow-.