LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2018 >> S6 Premium Plus >> Repair and Diagnosis (Single Page) >> Transmission >> Transmission Control Systems >> Engine System & Transmission System (Diagnostics - CTGE - 7 Of 8) >> Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions (My-2015) >> Monitor-ID ($3D): EVAP Valve Function Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor-ID ($3D): EVAP Valve Function Check

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check the results of components that are not continuously monitored".

Select "Monitor-ID ($3D)".

-- Select the desired "Hex-ID".

-- Check specified values at idle.

(Hex-ID) DTC Component or System Min. Max. Additional Information
$80 P0441 Tank vent valve check, Active test Air balance at idle OK. 0.200012 1.999 Refer to DTC P0441 in the DTC summary table. Engine Control Module --, 2015 MY => P0441
$88 P0441 Tank vent valve check, Active test, Oxygen sensor deviating in lean direction (can only test OK). 1.0 (counts) 65535 (counts) Refer to DTC P0441 in the DTC summary table. Engine Control Module --, 2015 MY => P0441

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals