6.2.4 Baseplate for Distance Regulation Control Module - J428-, Removing and Installing, Version 2 from MY 2017

Special tools and workshop equipment required

Removing

Remove the distance regulation control module. Refer to 6.2.1 Distance Regulation Control Module - J428-, Removing and Installing .
Release the retaining tabs -1- in the direction of -arrow-.
Remove the cover -2- from the distance regulation control module -3-.
Release the locking mechanisms -2- in the direction of -arrows-.
Remove the distance regulation control module from the stud bolts -1-.
Remove the retaining plate -3- from the Distance Regulation Control Module - J428- -4-.

Installing

Install in reverse order of removal and note the following:

NOTE:

The stud bolts in the adapter frame are pre-set. If necessary, correct the setting.

Place the control module on a soft and clean surface.
Measure the dimension -a- at the upper stud bolt using the - VAS6335- and correct if necessary.

Dimension -a- = 40.25 ± 0.5 mm

Measure the dimension -a- at the lower stud bolt using the - VAS6335- and correct if necessary.
Dimension -a- = 38.2 ± 0.5 mm

Position the retaining plate -3- onto the distance regulation control module -1-.
Carefully press the new quick release -4- onto the stud bolt -2-.
Turn the quick release clockwise onto the retaining plate to the stop -arrow-.