6.2.6 Clip on Distance Regulation Control Module - J428-, Replacing, Version 1
NOTE:
- If the stud bolts were removed, then the clips on the distance regulation control module must be replaced.
- The clips cannot be removed without being damaged.
Procedure
- Remove the distance regulation control module retaining plate. Refer to 6.2.2 Distance Regulation Control Module - J428- Retaining Plate, Removing and Installing, Version 1 .
- Release the retaining tabs in direction of -arrows-.
- Remove the cover -2- from the Distance Regulation Control Module - J428- -1-.
- Remove the stud bolt -1- using a suitable tool -2-.
- Place a screwdriver between the hook and the housing.
- -A-: Bend every hook all the way around with the screwdriver until it audibly breaks off.
- -B-: To prevent the broken hook from getting caught on the housing, remove it from the inside of the clip using needle nose pliers.
- -A-: Insert the new clip into the hole in the housing from the left and then press on it by hand until it clicks into place.
- The tabs on the clip must sit correctly in the recesses.
- -B-: Install the stud bolt.
- The stud bolt must be parallel inside the hole and correctly aligned to the clip.
- Turn the stud bolt into the distance regulation control module up to the dimension -a-.
- Dimension -a- = 44.3 mm.
- Repeat this procedure on all the other clips, if necessary.