6.2.8 Clip on Distance Regulation Control Module - J428-, Replacing, Version 3

NOTE:

If the same distance regulation control module is reinstalled the clips on the distance regulation control module must be replaced.
The clips cannot be removed without being damaged.

Procedure

Place a screwdriver between the hook and the housing.
To prevent the broken hook from getting caught on the housing, remove it from the inside of the clip using needle nose pliers.
Insert the new clip into the hole in the housing from the left and then press on it by hand until it clicks into place.
Bend every hook all the way around with the screwdriver until it audibly breaks off.
To prevent the broken hook from getting caught on the housing, remove it from the inside of the clip using needle nose pliers.
Insert the new clip into the hole in the housing from the left and then press on it by hand until it clicks into place.