Monitor-ID $A6: Mis-Fire Detection Cylinder 5 Data
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 06: Check / test the results of components that are not continuously monitored".
Select "Monitor-ID $A6".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID | DTC | Unit-ID | Component or System | Test Value | Min. | Max. | Additional Information |
|---|---|---|---|---|---|---|---|
| $0B | P0305 | 24 | Misfire Cylinder 5, Average Value Over 10 Driving Cycles. | 1 | 0.0 counts | 65, 535.0 counts | Refer to DTC P0305 in the DTC summary table.Engine Control Module --, 2019 MY => P0305 |
| $0C | P0305 | 24 | Misfire Cylinder 5, Current Driving Cycle. | 3 | 0.0 counts | 65, 535.0 counts | Refer to DTC P0305 in the DTC summary table.Engine Control Module --, 2019 MY => P0305 |
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.