Driver Assistance Systems Front Camera -R242-, REMOVING AND INSTALLING, VERSION 1, MFK2: Removing
- Component location. Refer to COMPONENT LOCATION OVERVIEW - SENSORS AND CONTROL MODULES IN CENTER SECTION OF VEHICLE .
-- To prevent damage, cover the upper edge of the interior rearview mirror with adhesive tape.
-- Unclip the cover -1- using the clip release lever from the : VAS6845 in direction of -arrows A, B and C- by carefully inserting the clip release lever between the windshield and the cover.
-- Repeat the procedure on the opposite side.
-- Disengage the front cover and remove toward the rear.
-- Position the screwdriver -2- on the retaining pin -3- as shown and slowly press the front camera -6- out of the clip -4- in direction of -arrow-.
-- Remove the front camera out of the guides for the baseplate -1-.
-- Disconnect the connector -5- and remove the front camera.
Lens, Removing
-- Free up the connector -2-.
-- Release and disconnect the connector -2-.
-- Release the retaining tabs -1- at the retaining plate.
-- Swivel the lens -3- downward, out of the retaining plate -1- in direction of -arrow-.