Memory Address, Coding
On vehicles with remote-control central locking, every new or non-encoded remote unit must first be re-coded for the central locking control module.
-- Switch ignition on; leave key in ignition.
-- Mechanically lock vehicle at left front door, using second key.
-- On remote unit, press "Open" button once. A short horn signal will sound.
The "Open" button is pressed once for programming the first, or a single, remote unit.
When programming additional remote units for the second, third or fourth memory addresses, press the "Open" button two, three or four times, in one-second intervals.
Example: press the "Open" button once, wait 1 second, then press once again to program the second remote unit.
-- After 6 seconds, press "Open" button once to activate the coding process.
The remote unit will now be coded, and it can be used to unlock the central locking system.
-- Switch ignition off.
The key must be removed from ignition before the remote unit can be used to lock the vehicle.
The coding process can be repeated up to 4 times for additional remote units. In between each remote unit coding, the ignition must be switched off.