Example of a Special Central Locking Coding
This is a case of an Audi A6 Wagon with central locking and anti-theft warning system. A safety central locking system is desired and setting the anti-theft warning system will be confirmed by triggering the 4-way flashers. The ultrasonic interior monitor has no On Board Diagnostic (OBD) capability.
| Vehicles with Central Locking and Anti-theft Warning System: | Answer | ||||||
|---|---|---|---|---|---|---|---|
| 1. | Is the vehicle a Wagon? | No = 0 | Yes = 256 | Yes = | 256 | ||
| 2. | Will the vehicle have a single door opening and a rear lid subsequent locking (safety central locking)? | No = 0 | Yes = 4 | Yes = | 4 | ||
| 3. | Will the power windows be shut off with driver's door open and ignition "off" (USA door locking logic)? (USA = yes) | No = 0 | Yes = 2048 | Yes = | 2048 | ||
| 4. | Will the anti-theft warning system be activated? | No = 0 | Yes = 8 | Yes = | 8 | ||
| 5. | Will the anti-theft warning system setting be confirmed by triggering the 4-way flashers?(1) | No = 0 | Yes = 4096 | Yes = | 4096 | ||
| 6. | Will the anti-theft warning system setting be confirmed by triggering the anti-theft warning horn?(1) | No = 0 | Yes = 1024 | No = | 0 | ||
| 7. | Does the control module for ultra-sound sensors -J347- (interior monitor) have OBD, i.e. address word 45; is there a message from the control module for ultra-sound sensors? | No = 128 | Yes = 0 | No = | 128 | ||
| Total (coding): | 06540 | ||||||
|
|||||||
Initiating Central Locking System Coding
Indicated on display:
| Rapid data transfer HELP Select function XX |
-- Press buttons 0 and 7 to select "Code Control Module" function 07.
-- Press Q button to confirm input.
Indicated on display:
| Code control module Enter code number XXXXX (0-32000) |
-- Enter a valid 5-digit code using buttons (for example 03212).
Determine the valid coding for the current central locking pump using the standard coding table. Refer to Standard Coding Table . Also use the answers for individual coding. Refer to Coding Questions for Individual Central Locking Functions .
--
| Code control module Q Input code number 03212 (0-32000) |
-- Indicated on display
-- Press Q button to confirm input.
Indicated on display:
| 8L0862257E CV-Pump, Alarm → Coding 03212 WSC 06812 |
-- End coding procedure by pressing the → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
-- Press buttons 0 and 6 to select "End Output" function 06.
Indicated on display:
| Rapid data transfer Q 06 - End output |
-- Press Q button to confirm input.
"Read Measuring Value Block" function 08 can be used to check the central locking pump coding in display group 004. Refer to READ MEASURING VALUE BLOCK, FUNCTION 08 .