Windshield Projection Head Up Display Control Module, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI

-- Press out the cover -2- from the instrument panel -1- using the Wedge Set:T10383 .

-- Cover the control module -2- with a soft towel.

Courtesy of AUDI

-- Remove the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .

CAUTION:

There is a risk of destroying the windshield projection head up display control module.

- Only remove the designated bolts from the control module.

- Never remove the bolts for the housing upper section.

-- Remove the bolts -1, 3 and 4-.

-- Lift the control module -2- out slightly and disconnect the connectors -3 and 4-.

Courtesy of AUDI

-- Free up the wiring harness -1- -arrow-.

-- Remove the control module.

Removing the exterior bracket:

Courtesy of AUDI

-- Mark the installation position of the bracket -1- on the instrument panel crossmember.

-- Remove the instrument panel. Refer to INSTRUMENT PANEL, REMOVING AND INSTALLING .

-- Remove the nuts -arrows-.

-- Remove the bracket -1-.

Removing the inner bracket:

Courtesy of AUDI

-- Remove the instrument panel. Refer to INSTRUMENT PANEL, REMOVING AND INSTALLING .

-- Mark the installation position of the bracket -1- on the instrument panel crossmember.

-- Remove the nuts -arrows-.

-- Remove the bracket -1-.