Driver Assistance Systems Control Module -J1121-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi SQ8, 2022 Audi RS Q8, 2022 Audi Q8, 2021 Audi SQ8, and 2021 Audi RS Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Lay the carpet at the left front of the center console. Refer to CARPET, REMOVING AND INSTALLING .

-- Unclip the front seat mount from the vehicle floor. Refer to OVERVIEW - FRONT SEAT .

-- Remove the nuts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear emergency release cable -1- from the Driver Assistance Systems Control Module -J1121- bracket and place it aside.

-- Unclip the wiring harness from the impact guard -1- -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -2 and 4-.

-- Lift the Driver Assistance Systems Control Module -J1121- with the bracket -3- and impact guard -1- just until the connectors are accessible.

Vehicles with Driver Assistance Systems Control Module -J1121- "Low"

Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws -arrows-.

-- Loosen the clip -3- and remove the impact guard -4-.

-- Release and disconnect the connectors -2-.

-- Remove the Driver Assistance Systems Control Module -J1121- -1-.

Vehicles with Driver Assistance Systems Control Module -J1121- "High"

Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws -arrows-.

-- Loosen the clip -3- and remove the impact guard -4-.

-- Release and disconnect the connectors -2-.

-- Remove the Driver Assistance Systems Control Module -J1121- -1-.