Overview - Laser Distance Regulation Control Module
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi SQ8, 2022 Audi RS Q8, 2022 Audi Q8, 2021 Audi SQ8, and 2021 Audi RS Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Cover
- For the washer nozzle
- Laser Distance Regulation Control Module -J1122-
- Removing and Installing. Refer to Laser Distance Regulation Control Module -J1122-, REMOVING AND INSTALLING .
- Adjusting. Refer to LASER SENSOR (Laser Distance Regulation Control Module -J1122-), ADJUSTING .
- Mount
- For Laser Distance Regulation Control Module -J1122-
- Removing and Installing. Refer to ADJUSTER FOR Laser Distance Regulation Control Module -J1122-, REMOVING AND INSTALLING .
- Bolt
- 6 Nm
- Adjuster
- Removing and Installing. Refer to ADJUSTER FOR Laser Distance Regulation Control Module -J1122-, REMOVING AND INSTALLING .
- Note the adjustment dimension. Refer to Installing - Measure the dimension -a- at the adjuster using the : VAS6335 and correct if necessary. .
- Spring
- Washer Fluid Hose
- Spray Nozzles
- For Laser Distance Regulation Control Module -J1122-
- Overview. Refer to OVERVIEW - HEADLAMP WASHER SYSTEM
- Bolt
- Tightening specification. Refer to OVERVIEW - HEADLAMP WASHER SYSTEM
- Quantity: 2
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Quantity: 4
- Bolt
- 6 Nm
- Quantity: 2
Tightening Specifications and Sequence Laser Distance Regulation Control Module J1122 with bracket 5
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 to 4- | Install by hand all the way |
| 2. | -1 to 4- | 4 Nm |