61 35 015 Removing And Installing (Replacing) Control Unit For Car Access System
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
Necessary preliminary tasks:
- Remove TRIM PANEL FOR PEDAL ASSEMBLY .
Unfasten plug connection (2) and disconnect.
IMPORTANT:
Carefully unlock and disconnect associated plug connection for ribbon cable (1).
Replace ribbon cable (1) if
- plug connection for ribbon cable (1) is damaged
- control unit for Car Access System (3) is replaced
The ribbon cable leads to the ignition starter switch.
Release screw (4) and remove control unit for Car Access System (3) in direction of arrow.
Installation:
Feed guide (1) of control unit for Car Access System (2) correctly into associated mounting.
Replacement:
Carry out PROGRAMMING/ CODING
Version with independent heating:
Initialize all INDEPENDENT HEATING REMOTE CONTROLS .