Dial Indicator Measurements: Notes
The dial indicator is used to measure the travel or movement of a specific item. It can also be used to measure axial and radial runout. In engine measurement applications, the dial indicator can be used to measure valve guide wear, axial movement of the crankshaft (thrust), and runout of flywheels and harmonic balancers.
First, it is important to familiarize yourself with Dial Indicator construction. The face of the dial indicator consists of a moveable bezel which is also attached to the large measuring scale. This allows the tool be brought to the "zero point" when needed.
The main measuring device is the contact point. The contact point (1) is placed against the object to be measured. Usually, the contact point is rounded or has a ball bearing. This allows for a more accurate measurement.
The measuring face of the dial indicator consists of 2 scales. The smaller scale is for the "coarse" measurement which is in graduations of 1 millimeter. One revolution of the small scale is 10 millimeters.
The large scale is in graduations of.01 millimeter and the scale goes from zero to one hundred. Therefore, one revolution of the large scale is one millimeter.
The dial indicator also needs to be held in place when taking a measurement. This requires a stand or base. Depending upon the application, these stands can be a clamp type, magnetic or a threaded base.
When taking a measurement, place the contact point on the object to be measured. The dial indicator must be pre-loaded slightly to prevent the measurement from bottoming out.
When reading the scale, be sure to "zero" the dial indicator first. If the readings to be taken are less than 1 millimeter, you do not need to use the small scale. If the readings are larger than 1 millimeter, be sure to factor the small scale into your measurement.