13 62 560 Removing And Installing/Replacing Air-Mass Flow Sensor (N62, N62TU)

Necessary preliminary tasks: 

• Read out fault memory of DME control unit; if necessary, work through test schedules
• Switch off ignition

Open clips (1).

Unlock connector (2) and remove.

Unfasten clip.

Remove top section (3) of intake filter housing.

Installation: 

Check sealing ring between air-mass flow sensor and air intake hose for damage, replacing if necessary.

Fig 1: Identifying Clip, Connector And Top Section Of Intake Filter Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws.

Pull air-mass flow sensor (1) out of upper section of intake filter housing.

Fig 2: Pulling Air-Mass Flow Sensor Out Of Upper Section Of Intake Filter Housing

Courtesy of BMW OF NORTH AMERICA, INC.