27 10 700 Removing And Installing/Replacing Control Unit For Transfer Box (ATC 300)

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Replacement:
Before and after replacement, execute the "Repair" service function with the BMW diagnosis system.

Necessary preliminary tasks:

Remove side trim panel (1) and entrance strip trim (2).

Pull back floor trim (carpet) towards rear.

Fig 1: Identifying Side Trim Panel And Entrance Strip Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Remove inlay (1).

Fig 2: Identifying Inlay

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws.

Tightening torque, 8 N.m.

Fig 3: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect connector (1).

Modify control unit.

Fig 4: Identifying Control Unit Connector

Courtesy of BMW OF NORTH AMERICA, INC.