61 35 107 Removing And Installing/Replacing Junction Box Electronics

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Release screws (1).

Remove air duct (2).

Fig 1: Identifying Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Slacken wiring harness in cable holder (2).

Fig 2: Identifying Cable Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Fig 3: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Lever holders (1) at bulkhead out of fuse box (2) in direction of arrow.

Lower fuse box (2).

Fig 4: Removing Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Fig 5: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Pull junction box electronics (2) out of fuse box.

Installation:

Make sure junction box electronics (2) is correctly seated in fuse box plug connection.

Fig 6: Pulling Junction Box Electronics Out Of Fuse Box

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: