61 00... Notes On Handling Optical Fibres
IMPORTANT:
To avoid damage when handling optical fibres, comply with the following points:
- The minimum permitted bending radius is 25 mm
- Do not subject optical fibres to compressive and tensile load
- Protect optical fibres against the effects of heat
- ≥85 °C (e.g. during welding work, drying work with infrared heater or hot air blower)
- Fibre-optic cables are permitted to show only one junction point (bridge), replace fibre-optic cables if necessary
NOTE:
The optical fibres are colored differently as follows:
Follow instructions for PROCESSING CABLES AND OPTICAL FIBRES .
- Green = MOST (Media Oriented Systems Transport) optical fibre
- Yellow = ISIS (Intelligent Safety and Integration System) fibre-optic cable
- Orange = repair fibre-optic cables
Follow instructions for PROCESSING CABLES AND OPTICAL FIBRES .