41 00... Bonding Steel On Steel

IMPORTANT: These repair instructions apply to structural components.
Such components include engine supports, A-pillars, B-pillars, etc.
Follow the vehicle-specific repair instructions.
Only use the repair procedures described there.
Conform with safety regulations . See 41 00... SAFETY AT WORK or 41 00... INFORMATION ON HAZARDS !

Overview of topics

Equipment
Preparing the surface
Bonding coat
Hardening times
Subsequent treatment

1.0 Equipment

2.0 Preparing the surface

For better adhesion, remove oxide film and paint from the adhesive areas with a stainless steel wire brush or special sandpaper.
Clean bonding surfaces with cleaning agent R1.
Allow cleaned surfaces to dry for approx. 5 minutes.

Bonding surfaces must be completely dry.

3.0 Adhesive application

Processing temperature of glue cartridge 18°C - 30°C.
Object temperature, vehicle and new parts, min. 15°C.
After applying the adhesive, check whether an adhesive component has emerged at the back of the glue cartridge. If yes, break off the bonding procedure. Clean new part. Use new glue cartridge.
Join components and secure in position.
Remove excess adhesive. Do not use solvent cleaning agents.

4.0 Hardening times

Refer to NOTES REGARDING ADHESIVE K1 .

5.0 Subsequent treatment of bonding surfaces

Protect the repair area with cavity sealant.