Sequence for replacement of DSC unit or DSC control unit

After replacement of the DSC unit or of the DSC control unit, the control unit codes itself. In this operation, the vehicle identification number is also stored. This means that adjustment of the steering angle sensor with DSC 8/DSC 8Plus is not required. For every startup (ignition on), the DSC compares the stored vehicle identification number with the current vehicle identification number. DSC codes itself according to the type of vehicle if the vehicle identification numbers do not match. This opportunity is used to reset the learned adjustment values of the sensors to the base setting (exception: longitudinal acceleration sensor). The following work is to be carried out:

1. Encoding DSC

   (RPA data is encoded; E90 all wheel drive: SZL data is encoded)

2. Brake bleeding procedure for DSC unit
3. Brake line mix-up test:
4. Initialize Run Flat Indicator