61 13... Socket housing (radio connector), Hybrid System MQS/MPQ

Manufactured by AMP: The following contact types without strand sealing can be fitted in the connector housings:

Removing MPQ contacts from radio connector:

Press lock (1) in direction of arrow.

Detach secondary lock (2) from radio connector.

Fig 1: Pressing Lock And Detaching Secondary Lock From Radio Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Feed special tool 61 0 314 (61 1 135) past side of contact.

Press special tool 61 0 314 (61 1 135) in direction of arrow.

Pull wire (1) with socket contact out of radio connector (2).

Fig 2: Using Special Tool (61 1 135) To Remove Socket Contact From Radio Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Removing MQS contacts from contact carrier:

Press lock (1) in direction of arrow and pull housing (2) out of radio connector.

Fig 3: Pressing Lock To Remove Housing From Radio Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Press lock (1) in direction of arrow. Pull contact carrier (2) out of housing (3).

NOTE: When the contact carrier is pulled out, the secondary locks of the socket contacts are raised.

Fig 4: Identifying Lock, Contact Carrier, And Housing

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Schematic diagram shows the 8-pin socket housing by way of example.

Hold down retaining hook (1) of socket contact in opening of contact carrier with a small screwdriver.

Pull wire with socket contact in direction of arrow as far as secondary lock (2).

Fig 5: Identifying Retaining Hook And Secondary Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Hold down retaining hook in secondary lock (1) again. Pull wire with socket contact (2) out of contact carrier (3).

Fig 6: Removing Cable With Socket Contact From Secondary Lock And Contact Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Removing MPQ contacts from contact carrier:

Remove contact carrier (1) with MQS contacts from radio connector.

Raise lock (2) on radio connector.

Pull contact carrier (3) out of radio connector.

Fig 7: Identifying Contact Carriers And Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Press lock (1) in direction of arrow.

Pull secondary lock (2) in direction of arrow completely out of contact carrier (3).

Fig 8: Identifying Lock, Secondary Lock, And Contact Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Press special tool 61 0 314 (61 1 135) on inside of contact into contact carrier (2).

Pull wire with socket contact (1) out of contact carrier (2).

Fig 9: Using Special Tool (61 1 135) To Remove Socket Contact From Contact Carrier

Courtesy of BMW OF NORTH AMERICA, INC.