General Notes For Embossed Vehicle Identification Numbers

This procedure is applied to all vehicles where the vehicle identification number is positioned on the carrier support.

For the repair new parts with an embossed vehicle identification number can as a rule be ordered from BMW. If this is not possible, observe country-specific regulations.

The IGEF number (bodyshell number) is omitted when the wheel arch is replaced.

If a VIN is embossed into the replacement surface in addition to the original VIN (e.g. if the original VIN has been tampered with), the following applies: The vehicle-specific repair instructions describe the procedure.

The protective film used as standard is omitted after the VIN has been embossed. Ensure that layer thicknesses are small.

Observe national/country-specific regulations.