Conversion Of Coil-Spring Assembly To Connector System "MQS"

Following steps are important for the conversion:

1. Remove cladding of short earth cable. 
   Fig 1: Identifying Earth Cable With Cladding (Original Condition)

   Courtesy of BMW OF NORTH AMERICA, INC.
   Fig 2: Identifying Earth Cable Removed From Cladding

   Courtesy of BMW OF NORTH AMERICA, INC.
2. Fit the cable and plug in. 
3. Establish tension relief as shown in the following graphic: 
   Fig 3: Identifying Cable Strap

   Courtesy of BMW OF NORTH AMERICA, INC.

   Attach cable ties as follows:

   • Cut end faces downwards.
   • The part of cable between the coil-spring assembly and cable tie is not under tension (loop greater than 5 mm).